Mag-Dro
MADE IN THE USAMade in the USA

Magnetic Caliper Base

Magnetic Caliper Base

Mitre Slot Base (Slot, Clamp, or Screw)

Fits most 3/4" mitre slots

Mitre Slot Base

MAG-DRO's tools allow you to quickly and easily anchor your calipers to make precision measurements.

MAG-DRO

Click Here for NewWoodworker.com's review by Tom Hintz

 

Tips and Tricks Magnetic Caliper Base Mitre Slot Base
Tips and Tricks Summary View PDF   Video View PDF   Video
Installation and Introduction View PDF   * View PDF   *
Table Saw Tune-up    
Fence Alignment View PDF (1) Video View PDF   Video
Saw Blade Alignment View PDF (1) Video View PDF (2) Video
Blade Run-out View PDF   Video View PDF (2) *
Cross Slide Play *   Video N/A   N/A
Table Saw Uses    
Table Saw Blade Height View PDF (3) * View PDF (3) *
Tongue and Groove *   * * (2) *
Cutting an Exact Width Board View PDF   * View PDF (2) *
Cutting a Dado Without a Dado Blade View PDF   * N/A (2) N/A
Finger Joints *   * N/A   N/A
Other Uses    
DRO Router Table N/A   N/A * (4) *
Router Bit Adjustments * (3) * * (3) *
Planer Adjustments View PDF (5) * * (6) *
Part Inspection * (3) * * (3) *
Fixtures    
Height Gague View PDF   Video View PDF   *
 
Fraction to Decimal Conversion Chart View PDF
Zip File of All Available Tips .zip file     .zip file    

*Not available at this time. Please check back later.

Other items needed besides 6" calipers to achieve these measurements: (1) Needs a combination square or an elevated cross slide and painters tape; (2) May need a spacer piece; (3) Needs height gauge or angle plate; (4) Needs a spring, 2 cup hooks and 2 screws; (5) Needs a magnetic surface to attach to; (6) Needs an area to attach with screws or a clamp; (7) Needs very precise flat boards and measurements